![]() This changes the printer to "non Japan, CD-R Support, letter paper" mode. (Tip: Incase of warranty return you may want to reset the BIOS to the default which I believe is 2).į.ğor this example we will choose "Non Japan CD-R Support Letter Paper" by pressing RESUME 5 times followed by POWER once. 6 times you wish to abort and get back to the first menu 5 times Not Japan CD-R support letter paper 4 times Not Japan CD-R support a4 paper 3 times Not Japan No CD-R support letter paper 2 times Not Japan no CD-r support a4 paper ![]() Press RESUME this many times followed by POWER to pick one. You are in the Destination settings option.Į. To get to the Destination settings press RESUME 5 times (the light will be orange) then press POWER once. Keep this sheet to compare to the one after you change the settings.ĭ. (The Diagnostic sheet will list its ROM number and read "CDR SENSOR=OK" in red on the last line). If you are in Diagnostic mode the Diagnostic sheet will print. To be sure you are in the service mode before continuing press RESUME once - the light will turn Orange. Press RESUME again so the light turns green. You will notice the power light turn orange. While still holding POWER press RESUME once. ![]() Wait about 5 seconds before releasing RESUME but continuing to hold POWER. Hold down RESUME (Triangle pointed down) then push and hold down POWER. Turn off the printer but don't unplug it.ī.
0 Comments
Leave a Reply. |